Your water heater is one rather used and much more costly appliances in your home, and consumes a large regarding your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving at your home heating and costs.

Regular flushing of your water heater is considered the single most important step you can take to prolong its service life additionally, you will save energy. Over a period of time, sediments build up in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. This is not just destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most areas of the country, the average water heater lasts 3-5 years. Regularly flushing your water heater can double existence of your water heater from 3-5 to 7-10 years. And with the costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is critical in today’s affordable. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs in half. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a month or so.

To drain your water heater, you can find should set the thermostat to pilot (if it is a gas water heater) or turn the circuit breaker off (if it is electric heater). Failure to do so could result in overheating and severe damage to the actual heater. Next, close the water supply valve located on a water inlet line going into your water heater. You may then connect a garden hose to the drain valve located at the bottom of the heater tank. Open the drain and allow it working out until all of the water has emptied from the hot water heater. Then close the drain. Open the water supply valve and refill the central heater. You should also open a hot water faucet somewhere inside and stand there and watch it run for several minutes until the water flows out quickly. This will allow air to vent via the heater and the hot water lines. Finally, you can turn the thermostat to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your home to filter or condition the water so may less corrosive to your plumbing system, particularly in areas which have hard stream. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in location to discuss options and merchandise to fit the bill.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2